Connectors
| Ref | Plugs into | Family | Housing MPN | Terminal MPN | Pins | |
|---|---|---|---|---|---|---|
| J1 | ||||||
| J2 |
Wire list
The from/to table is the spec. Everything else is generated from it.
| # | From | Signal | To | AWG | Color | Twist | Length | + Twist | Check | |
|---|---|---|---|---|---|---|---|---|---|---|
| 1 | 151 | OK | ||||||||
| 2 | 151 | OK | ||||||||
| 3 | 151 | OK | ||||||||
| 4 | 150 | OK | ||||||||
| 5 | 150 | OK | ||||||||
| 6 | 151 | OK |
Lengths are in mm. "+ Twist" is the finished length plus twist take-up, rounded to the nearest mm. It is not a cut length: it leaves out the wire inside each connector housing, which the shop adds.
Twisted pairsUntwisted lengths are measured from the back of each connector housing.
| Pair | Wires | Lay length | Untwisted at each end | Direction | |
|---|---|---|---|---|---|
| TP1 | 1 VBAT + 6 GND | mm | J1mmJ2mm | ||
| TP2 | 2 TX + 3 RX | mm | J1mmJ2mm |
Heat shrink, sleeving & labels
Each item is placed by its distance from a connector.
| Item | Type | From | Distance | Length | Spec / label text | |
|---|---|---|---|---|---|---|
| HS1 | Heat shrink | mm | mm | |||
| HS2 | Heat shrink | mm | mm | |||
| SL1 | Sleeving | mm | mm | |||
| L1 | Label | mm | mm | |||
| L2 | Label | mm | mm |
Side view, to scaleDistances run from the back of the connector housing to the near edge of the item.
J1
HS1
HS2
L1
L2
J2
10
10
20
40
40
150 mm overall
Heat shrinkLabelSleeving
Drawing notes
One per line. Printed on the drawing.